BISON CAR MIRROR 2 ml - for rear view mirrors

Very strong special transparent glue for gluing rear-view mirrors to safety glass.

The set is intended for gluing two rear-view mirrors (contains 2x grid and glue).

The glue is intended for gluing mirrors that have a metal base. If you are gluing a mirror with a plastic base, use BISON CAR TAPE. Withstands temperatures from -50°C to + 150°C. SCOPE OF USE: Rear view mirrors with metal base. INSTRUCTIONS FOR USE: The glued parts must be clean, dry and degreased. Mark the glued area on the safety glass. Cut the grill to the size of the mirror base. Apply a sufficient amount of glue to the base of the rearview mirror and attach the wire mesh. Press the rearview mirror onto the marked part of the safety glass and fix it for at least 1 minute. The glued joint reaches handling strength after 15 minutes and functional strength after 72 hours. Remove uncured glue with acetone, cured glue only mechanically. Store in a dry and cool place. IMPORTANT: Do not use at temperatures below +10°C.

Safety notice

Signal word: DANGER Content of dangerous substances: methacrylic acid, monoester with propane-1,2-diol; acrylic acid; neopentyl glycol propoxylate diacrylate; 2'-phenylacetohydrazide H412 - Harmful to aquatic organisms, with long-term effects. H318 - Causes serious eye damage. H317 - May cause an allergic skin reaction. H335 - May cause respiratory irritation. P101 - If medical attention is needed, have product container or label at hand. P102 - Keep out of the reach of children. P261 - Avoid breathing vapour. P280 - Wear protective gloves/goggles/face shield. P305+P351+P338 - IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if worn and if they can be removed easily. Continue rinsing. P310 - Immediately call a POISON CENTER/doctor. P501 - Dispose of contents/container according to national regulations. P403+P233 - Store in a well-ventilated place. Keep the package tightly closed.