Epoxy resin crystal clear for casting EZ 350

The epoxy resin in the hardener set contains a resin weighing 500 g + 200 g hardener, a total of 700 g. The epoxy system and the new hardener have been developed based on your requirements. UV stable, crystal clear, with the possibility of casting up to 9 cm thick. The system exhibits extreme transparency, minimal shrinkage and cures at room temperature. It is very friendly to the environment and your health, because almost no harmful fumes were measured during curing. It does not cause an allergic skin reaction under normal use.

The new hardener significantly suppresses oxidation and subsequent yellowing of the laminate. This new system is one of the highest quality lamination systems, thanks to the use of the highest quality raw materials on the market. The set is intended for pouring a 90 mm thick product. For example, you can water wooden table tops into a so-called rivertable. Instructions are given on the product packaging.

The photoluminescent pigment P350 can also be added to the resin, in an optimal ratio of 30 g per 100 g of resin. After lighting, the cured resin glows for up to 12 hours. You can find the pigment HERE. Many interesting decorations can be created from clear epoxy resin Video HERE.

Casting resin is intended for casting or potting. It is often referred to as casting resin, casting resin, liquid resin, potting resin, cast resin or jewelry resin.

Use:
- potting resin: for potting any materials, wood resin, table resin, casting the image into crystal resin
- watering in resin: watering butterflies and beetles in resin, insects in resin, flowers watered with resin
- resin casting: using molds any shapes, orgonites, resin jewelry, resin earrings, crystal resin jewelry

Technical specifications:
- two-component resin
- crystal clear - like glass
- UV stable
- self-leveling
- smooth surface without bubbles
-

Ingredients:
- EZ350 epoxy resin can be perfectly colored with dedicated pigments
- Photoluminescent - luminous powder and metallic powders can be added to the resin

- the maximum recommended replenishment is up to 20% of the total volume

Recommendation:
when encapsulating permeable, porous materials, first close the pores with a suitable penetration, or
- processing temperature (mixing, casting) should not fall below 20 degrees. Celsius
- during curing there should be no major temperature changes, this has a negative effect on the cured surface

Recommended use:

Wherever casting or casting with a perfectly clear resin is required, without bubbles in the volume

Technical description

Mixing ratio: 40 g hardener per 100 g resin. The mixture must be mixed thoroughly. ATTENTION! The mixing ratio of the resin component and the hardener is by weight. In order to maintain the ratio, it is necessary to weigh the parts, volume metering cannot be used!

The solidification rate depends on the strength of the casting. The thicker the casting, the faster it hardens due to the effect of exothermic reactions. Therefore, it is recommended to operate at room temperature below 23 ° C to reduce the risk of high exothermic temperature. For more information, read the instructions on the packaging.

Weight 700 g contains:
resin - 500 g
hardener - 200 g